Have a question about our timber products, or want to know more about our processes?
Use the form below to submit your question. It will be promptly reviewed and answered by our technical team.
"*" indicates required fields
This excavator is "vibrating" in soldier "H" piles with a vibro pile driver on a residential job site. This job site happens to be a peat bog. The H piles on this job go to 20' deep and will have lagging (generally 4" x...
These 12" x 48" x 20' Crane Mats were placed on top of a Bridge Deck for a wear surface. The bridge is in an industrial site and was getting beat up by constant heavy truck traffic. This will extend the life of the...
These mats are going to a customer in Washington for use on a Wind Farm project. These are fine looking mats, straight, square, flat topped, no wane and are built with 6 rods 1-1/4" diameter. They have notches or daps in the end for...
Digger mats feature a cable from the top of the mat for dragging the mats into position, typically with an excavator. Sometimes if the mats are used as just support mats (like a Crane Mats) the mats can be flipped over and the cables...
these are 12" x 48" x 30' long Heavy Duty Crane Mats. Important points are flat top construction so that a Large Crawler Crane is not having to cross any "steps" in the mats. When the boom is up on some of these huge...
These 2 BIG Wedges are 36" tall x 36" wide and 120" long with a 2" toe and 36" high at the heel. Used for leveling up a mobile Crane Truck on a severe slope. This slope is about 30%. Notice the yellow Certified...
Here is a project that is using all forms of standard matting, we have Crane Mats on the base (over the geotextile fabric) and then steel Rig Mats lying crosswise on top of the Crane Mats, followed finally by Access Mats on top to...
If there is any question what Crane Mats are for this picture should answer the question. A wide stable base makes it "stable" for a Pile Driver to set up and get consistent results. Piles have to be consistently placed in the correct location....
These 12" x 48" x 20' off-set Crane Mats are being delivered to a windfarm site in eastern Alberta today. Weather is cold and crisp, no snow yet! Notice the larger "dap" in these mats, these are built using 2 shorter timbers in the...
These mats are being delivered to a wind farm that is being built east of Calgary in Alberta. The mats will we laid out in pads and a large heavy lift Crawler Crane will be erecting the poles and nacelle and blades of the...
These large Crane Mats are for a special job in Alberta where 72" wide mats was required by the engineer. We produced 5' and 10' and 20' mats so that everything fit into a grid.
You are looking at some fresh Crane Mats just produced and shipped. These are made from Hem/Fir #2 and btr Full Sawn special production just for us. They are 12" x 48" x 20' long and we make them here every day. Call us!...
You have no products in your quote list or cart.
